Matrix E30 Manual Del Usuario página 3

RESISTANCE TOGGLES
HANDLEBAR
PULSE GRIPS
WATER BOTTLE HOLDER
TOP HAND RAIL
SWING ARM
FOOT PADS
PEDAL ARM
TRANSPORT HANDLE (REMOVE BEFORE USE)
4
MXR20_AG_E30_E50_r1_0_A.indd 4-5 MXR20_AG_E30_E50_r1_0_A.indd 4-5
POWER CORD SOCKET
E30 SHOWN
A Open HARDWARE FOR STEP 1.
1
B Remove 4 PRE-INSTALLED SCREWS (5) and
TOP CAP COVER (6)from MAIN FRAME (4).
CONSOLE
C Carefully pull the CABLE (1) through the
CONSOLE MAST (2) using the LEAD WIRE
(3) located inside the CONSOLE MAST (2).
D Attach CONSOLE MAST (2) to MAIN
FRAME (4) using 4 BOLTS (A) and 4 FLAT
WASHERS (B). Tighten to 40 Nm / 29 lb-ft.
CONSOLE MAST
E Attach the TOP CAP COVER (6) to the MAIN
FRAME (4) using 4 PRE-INSTALLED SCREWS (5).
F Attach the CONSOLE MAST BOOT (7) to the
TOP CAP COVER (6) by snapping it into place.
TOP CAP
7 2
1
LINK ARM
A Open HARDWARE FOR STEP 2.
2
B Slide HANDLEBAR (8) onto
the CONSOLE MAST (2).
Hardware For Step 1
C Attach using 1 FLAT WASHER
Description Qty
(E), 1 HANDLEBAR CAP (9), 1
A Bolt 4
FLAT WASHER (F), 1 SPRING
B Flat Washer 4
WASHER (G) and 1 BOLT (H).
Tighten to 40 Nm / 29 lb-ft.
Note: Be careful not to pinch
any wires while attaching the D Repeat on other side.
upper assembly.
3
1
A
B
5 2
6
4 5
Hardware For Step 3
Description Qty
E Flat Washer (25 mm) 2
F Flat Washer (19 mm) 2
G Spring Washer 2
H Bolt 2
8 E F H
9 G
E50
5
9/28/20 11:51 AM 9/28/20 11:51 AM