Safety Information - Basement Sentry 148104 Información De Seguridad

SAFETY INFORMATION

SAVE THESE INSTRUCTIONS. This manual contains important SAFETY WARNINGS and
OPERATING INSTRUCTIONS for the Basement Sentry Dual Float Controller. You will need to refer to
it before attempting any installation or maintenance.
ALWAYS keep these instructions with the unit so that they are easily accessible. Failure to read and
follow these warnings and instructions could result in property damage, serious injury, or death.
WARNING: Risk of electric shock. To reduce this risk, observe the following precautions:
• ALWAYS disconnect the pump and dual float controller from power before servicing or making
adjustments
• NEVER handle the controller, float switch, pump, or motor with wet hands or when standing on a
wet or damp surface while the pump or controller is plugged into power.
• MAKE SURE THERE IS A PROPERLY GROUNDED RECEPTACLE AVAILABLE. This controller
is wired with a 3-prong grounded plug. To reduce the risk of electric shock, the controller should
only be connected to a properly-grounded 3-prong receptacle. If you have a 2-prong receptacle,
have a licensed electrician replace it with a 3-prong receptacle according to local codes and
ordinances.
• NEVER bypass grounding wires or remove the ground prong from the controller.
• DO NOT use an extension cord. The electrical outlet should be within the length of the pump's
power cord, and at least 4 feet above the floor to minimize potential hazards from flood conditions.
• DO protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking
the cord.
• MAKE SURE the supply circuit has a fuse or circuit breaker rated to handle the power
requirements noted on the nameplate of the pump.
CAUTION: To reduce the risk of hazards that can cause injury or property damage, observe
the following precautions:
• DO NOT expose the controller to moisture, water, rain or snow.
• DO NOT operate the pump or controller if they have been damaged in any way.
• DO NOT use with pumps in pits handling raw sewage, salt water, or hazardous liquids. This
product is for use with groundwater applications only.
• DO NOT use in continuous duty applications such as fountains or ponds.
• DO NOT disassemble the pump or controller. If service is required, contact customer service at
1-800-742-5044.
NOTICES:
• The controller requires 115V (+/- 5%, 60Hz) to operate.
• The controller will not provide protection during a power outage. With the risk of property damage
from high water levels, the addition of a battery backup is recommended.
• After the initial installation, be sure to check operation by filling the sump with water and observing
the pump operation through one full cycle.
2