Completing The Installation - Basement Sentry 148104 Información De Seguridad

Installing the Dual Float Controller
This controller is a piggyback switch that powers the
Basement Sentry dual float. The controller will activate the
pump when either float is lifted, and will shut the pump off
automatically 10 seconds after the float drops.
1. Plug the controller into a properly grounded 3-prong
receptacle, then plug the pump into the receptacle on the
controller.
2. For a neater installation, secure the pump power cord and
float switch cord to the discharge pipe with wire ties or
hose clamps. Keep the cords separated from each other
on opposite sides of the pipe.

Completing the Installation

1. After installing the float and controller, be sure to test
pump operation by filling the sump with water until one or
both floats are raised. Observe the pump through one full
cycle. The pump should run for an additional 10 seconds
after the float drops. If the pump does not activate after
one or both floats are raised, call customer service at
1-800-742-5044.
2. Replace the pit cover, making sure not to pinch or crimp
the pump or controller wires with the cover. The pit cover
may have a hole/cutout that will allow the wire to pass
through, or a hole can be drilled in the cover if needed.
WARRANTY
This product is warranted for one year from the date of purchase or two years from the date of manufacture, whichever occurs first. Subject
to the conditions hereinafter set forth, the manufacturer will repair or replace to the original consumer, any portion of the product which proves
defective due to defective materials or workmanship. This warranty does not cover replacement parts for failure due to normal wear and tear.
To obtain warranty service, contact the retailer from whom the product was purchased. The manufacturer retains the sole right and option
to determine whether to repair or replace defective equipment, parts or components. Damage due to conditions beyond the control of the
manufacturer is not covered by this warranty. For warranty questions or service,
call 1-800-742-5044.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from failure to properly install, operate or maintain the unit in
accordance with printed instructions provided; (b) to failures resulting from abuse, accident or negligence; (c) to normal maintenance services
and the parts used in connection with such service; (d) to units which are not installed in accordance with normal applicable local codes,
ordinances and good trade practices; and (e) the unit is used for purposes other than for what it was designed and manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced under this warranty must be returned to the manufacturer at
such place as the manufacturer may designate, freight prepaid.
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED
BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL
SUCH IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER ANY CIRCUMSTANCES,
BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS OF,
OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES
OF ANY TYPE OR NATURE. THE LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON
WHICH SUCH LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not allow limitations
on duration of implied warranties or exclusion of incidental or consequential damages, so the above limitations may not apply to you.
In those instances where damages are incurred as a result of an alleged pump failure, the
Homeowner must retain possession of the pump for investigation purposes.
Sump Pump
Plug
4
115V
Outlet
Dual Float
Control