Warning
Intended use
This Comelit product was designed for use in the creation of audio and video communication systems in residential, commercial or
industrial settings and in public buildings or buildings used by the public.
Installation
All activities connected to the installation of Comelit products must be carried out by qualified technical personnel, with careful
observation of the indications provided in the manuals / instruction sheets supplied with those products.
Wires
Disconnect the power supply before carrying out any operations on the wiring.
Use wires with a cross-section suited to the distances involved, observing the instructions provided in the system manual.
We advise against running the system wires through the same duct as the power cables (230V or higher).
Safe usage
To ensure Comelit products are used safely:
• carefully observe the indications provided in the manuals / instruction sheets
• make sure the system created using Comelit products has not been tampered with / damaged.
Maintenance
Comelit products do not require maintenance aside from routine cleaning, which should be carried out in accordance with the
indications provided in the manuals / instruction sheets.
Any repair work must be carried out
• for the products themselves, exclusively by Comelit Group S.p.A.,
• for systems, by qualified technical personnel.
Disclaimer
Comelit Group S.p.A. does not assume any responsibility for
• any usage other than the intended use
• non-observance of the indications and warnings contained in this manual / instruction sheet.
Comelit Group S.p.A. nonetheless reserves the right to change the information provided in this manual / instruction sheet at any time
and without prior notice
Visto supports 433.92 MHZ radio frequency signal, which can transmit the signal and can remotely control any products that can receive
the same frequency.
The Wi-Fi and 433.92 MHZ radio frequency signal on VISTO are two independent signals and works independently.
Table of contents
3