Electrical Connection; Use And Maintenance - Kuppersbusch KI6750.OSR Instrucciones De Uso

EN
The board must be fitted 20 mm bene-
ath the under part of the stovetop.

Electrical connection

Before you connect the stovetop to
the mains, check that the voltage
and frequency match those specified
on the stovetop nameplate, which is
underneath it, and on the Guarantee
Sheet, or if applicable on the technical
data sheet, which you must keep
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
top housing or the oven housing, if it
is installed in the same unit.
Warning:
The electrical connection must
be properly grounded, following
current legislation, otherwise the
induction hob may malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
g. 1
38
high temperature that this type of
device attains.
Only the Küppersbusch
o f f i c i a l t e c h n i -
cal service can handle or repair the
appliance, including replacement
of the power cable.
Before disconnecting the hob
form the mains, we recommend
switching off the cutoff switch and
waiting for approximately 25
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
Use and
Maintenance
User instructions of the
Touch Control
HANDLING ELEMENTS (fig. 2)
1
General on/off sensor.
2
Cursor slider for controlling power.
3
Power and/or residual heat
indicator*.
4
Decimal dot of power and/of
residual heat indicator.
5
Direct access to "Power" function.
6
Activation sensor for "Block" or
"Stop&Go" functions.
7
Pilot indicator light "Block"
function activated*.
8
Activation sensor for "Full Flex"
function.
9
Pilot indicator light "Flex Zone"
function activated*.
10
"Minus" sensor for timer.
11
"Plus" sensor for timer.
12
Timer indicator.
13
Decimal dot of the timer.*
14
Activation sensor for "Flex Zone"
function.
15
Activation sensor for "Full Flex"
function.
16
Activation sensor for "Chef"
functions.
17
Pilot indicator light "Keep Warm"
function activated*.
18
Pilot indicator light" Melting"
function activated*.
19
Pilot indicator light "Simmering"
function activated*.
20
Pilot indicator light "Quick Boiling"
function activated*.
21
Pilot indicator light "Grilling"
function activated*.
22
Pilot indicator light "Pan Frying"
function activated*.
23
Pilot indicator light "Deep Frying"
function activated*.
* Only visible while running.
The manoeuvres are done by means
of the touch keys. You do not need
to exert force on the desired touch
key, you only need to touch it with
your fingertip to activate the required
function