Sinvest VGE Blue lagoon PROFIHEATER Manual Del Usuario página 5

production defect or other cause
11. Always remove the plug from the outlet when the device is not in use and/or during cleaning and
maintenance activities. The plug must be removed from the mains outlet by pulling on the plug itself.
Never pull on the lead to remove the plug from the outlet.
12. To reduce the risk of electric shock, the plug must not be inserted into or removed from the mains
outlet with wet hands and/or while you are standing in the water.
13. The device should never be immersed, in whole or in part, in water or any other liquid. Always install
outside the swimming pool or whirlpool.
14. The connection lead of the appliance may not be shortened and/or connected directly without a plug.
Devices with cut-off/shortened cables are excluded from warranty coverage.
15. Use of the equipment for any purpose other than that for which it was designed or developed is not
permitted. Use of the equipment for a purpose other than that for which it was developed by the
manufacturer may lead to unsafe situations.
16. If there is a risk that the device or parts thereof may freeze, appropriate measures must be taken to
prevent freezing damage. Damage caused by freezing is always excluded from warranty coverage.
17. The device has an IP54 protection rating and is splashproof. It is therefore not suitable or intended for
outdoor installation, where it may be exposed to weather conditions.
18. This device may only be used in accordance with the guidelines in this manual.
19. This device should not be used in combination with simple portable pools, whirlpools and spas.
MAINTENANCE
• Never immerse this device in water.
• The thermostat section may not be opened. If the thermostat section is opened, the warranty is
immediately void. Any repairs must be performed by the manufacturer.
• The element must not be contaminated by dirt or deposits. Always maintain a good calcium
balance.
INSTALLATION
Never install the Profiheater immediately after the pH regulator in your pool installation. The best place to
install the device in the pipe system is immediately after the filter and UV-C unit and before the chemical
feeder.
• The Profiheater is fitted with Ø63 mm couplings for glued fitting; glued reducers for connection to
Ø50 mm and 1½" female thread are included. If PVC pipes are used, make sure the connections to the
fittings are stress-free.
• Hose connectors are also included. Cut the hose adapter to the desired size, fit the rubber sealing ring
and screw it into the 1½" reducer hand tight.
• Never switch on the device without water or with insufficient flow. Therefore always install the
Profiheater horizontally, with the inlet and outlet at the top. This will ensure that there is always water in
the device, even if something should cause the pump to fail.
• Connect the pump to the Profiheater and start the pump. Check the system for flow and leakage.
• Insert the plug of the heating element in the mains socket and set the thermostat to the desired
UV-C and Pool equipment UV-C and Pool equipment
BLUE LAGOON PROFIHEATER 3KW MANUAL |
EN
5