Installing Batteries - DreamGEAR DGUN-853 Manual Del Usuario

INSTALLATION MANUAL
Warning: Please read this instruction manual carefully before installing and using your Plug 'N'
Play.
SECTION 1
PLUG 'N' PLAY COMPONENTS AND INSTALLATION
Thank you for purchasing the Plug 'N' Play. This product consists of a joypad console with built-in
software and an attached A/V cable. This product is PAL compatible only and comes a SCART
adapter.
Please read the setup instructions and precautions before attempting to connect the Plug 'N' Play.

Installing Batteries

Remove the cover on the back of the Plug 'N' Play and insert three AA
size batteries as shown to the right. For best results,
use three fresh, high quality alkaline batteries.
Use Size "AA" batteries x 3 (Not included)
Note:
1) When the batteries begin to lose its power, the Power indicator LED will begin to dim, and the Plug 'N'
Play will turn itself off.
2) Remember to take out the batteries when the Plug 'N' Play is not going to be used for a long time.
CAUTION:
* All batteries should be replaced by an adult.
* Do not mix old and new batteries.
* Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
* Different types of batteries or new and used batteries should not be mixed.
* Only batteries of the same or equivalent type are to be used.
* Batteries are to be inserted with the correct polarity.
* Exhausted batteries should be removed from the product.
* Do not use rechargeable batteries.
3