Initial Use; Mounting The Lamp; Switching The Light On / Off; Adjusting The Light - LIVARNO home 14152102L Instrucciones De Utilización Y De Seguridad

Safety / Initial use / Changing the light bulb
Before every use, verify the available mains
voltage matches the required operating voltage
of the light (see "Technical data").
Always unplug the mains plug, respectively,
from the mains prior to assembly, disassembly,
cleaning, or when the light will not be used for
extended periods.
Do not install the lamp on a wet or conductive
surface.
Only insert the light bulb in a dry
environment.
This lamp is not suitable for external
dimmers and electronic switches.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the illuminant from a close
distance during operation.
Do not use optical instruments to look at the
illuminant.
In order to disconnect the light completely from
the power supply, the mains plug must be
removed from the socket.
Only use the light bulbs specified in the chapter
"Technical data".

Initial use

Mounting the lamp

Note: Remove all packaging materials from the
product.
Loosen the threaded ring
socket .For model 14152202L use the
5
included tool .
9
14 GB/IE
from the lamp
7
Place the lamp glass
and bring it in the right position.
5
Screw the lamp glass
. Make sure it is correctly positioned. For
7
model 14152202L use the included tool
Use a clean, lint-free, dry cloth to insert the
illuminant .
1
Screw the illuminant
lamp socket .
5
Plug the mains plug
been professionally installed.
Your light is now ready to use.

Switching the light on / off

Touch the In-line switch
on or off.

Adjusting the light

(14152202L)
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Note: Never change the direction of the light
while it is switched on.
Allow the lamp to cool down completely.
Adjust the flexible lamp arm
position.

Changing the light bulb

Switch the lamp off.
RISK OF ELECTRIC SHOCK!
First unplug the mains plug
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the lamp to cool down completely.
Use a clean, lint-free, dry cloth when replacing
the illuminant .
1
Unscrew the defective illuminant
lamp socket , turning counter-clockwise.
5
Screw a new illuminant, clockwise into the
lamp socket .
5
over the lamp socket
6
to the threaded ring
6
9
clockwise into the
1
into a socket that has
3
to switch the lamp
2
to the desired
8
from the socket.
3
from the
1
.