Tips And Recommendations For Installation - SOMFY Solus 40 Guia

EN
2. 3. 2. Setting the end limits
The end limits can be set in any sequence.
Setting the upper end limit
Press the Λ button on the control point to raise the
motorised product to the upper end limit and turn the
corresponding setting screw to set the required upper
end limit.
Setting the lower end limit
Press the V button on the control point to lower the
motorised product to the lower end limit and turn the
corresponding setting screw to set the required lower end
limit.

2. 4. tiPS And RecoMMendAtionS foR inStAllAtion

2. 4. 1. questions about the Solus 40 ?
observations
The motorised
product does not
operate.
24 Images not contractually binding
5119112A000_SOLUS40_12LGS.indb 24
Possible causes
The wiring is incorrect.
The drive is in thermal protection.
The control point is not compatible.
Solutions
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check for compatibility and replace the
control point if necessary.
Copyright © 2007-2014 Somfy SAS. All rights reserved.
24/11/2014 11:11