Fireplace Installation - Dimplex Ignite 50 Serie Instrucciones De Instalación

Fireplace Installation

CAUTION: Ensure installation
direct contact with building vapor
barrier or insulation and meets all
local building code.
!
NOTE: A dedicated, properly
fused 13 Amp circuit is required,
rated for the appropriate voltage
(230-240V).
WA R N I N G : C o n s t r u c t i o n
and wiring must comply with
local building codes and other
applicable regulations to reduce
WARNING: To reduce the risk
persons, always use a licensed
electrician.
WARNING: To reduce the risk of
the vicinity of the heater.
1. Select a location that is not
susceptible to moisture and is
away from drapes, furniture and
2.
hardware from the box.
!
NOTE: Leave the front glass
safely, in the box until the time you
are ready to install it.
3.
dry and dust free location until
you are ready to install the
Installation
CAUTION: Two people will be
required for various steps of
this procedure.
This design of this unit allows three
recess,
surface mounted.
CAUTION:
mounting should be limited to ½
in. (12 mm) to ensure adequate
1. Prepare a wall with a framed
opening of 16 in. (40.6 cm)
high,
•
•
•
cm) wide, with a bottom sill
that is a minimum of 4 in.
(10.2 cm) deep. The sill can
be constructed to support the
front of the unit to allow the
power supply wires to easily
back of the unit and a pass thru
partial
or sub-
Sub-surface
7