Safety Instructions - ACME MW08 Manual De Instrucciones

GB
Installation
1. Plug the Nano receiver into a USB port of your computer.
2. Open the battery door and install battery (1 x AA).
Receiver Storage
Store or take out the Nano receiver from the Nano receiver storage
by push/pull the Nano receiver.
Trouble Shooting
1. Check Nano receiver connection; try to inserting Nano Receiver
to another USB port on your computer.
2. Connection between the mouse and the Nano Receiver. Re-
insert the Nano Receiver. Take out the battery and reinstall it.
Note
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including
interference that may cause undesired operation.

Safety instructions

• Do not disassemble the product or remove any parts
• Do not put the product into water or any liquid. Should this
happen, take the product off computer and contact your vendor
or after sales service center for maintenance
4