Tabla de contenido
Publicidad
PROPERTIES OF THE TOOL
The manual hammer drill is an ordinary electric tool, insulation Class II, which has been designed for drilling and hammering in
concrete, natural and artificial stone, marble, etc., using working tools with an SDS Plus chuck system. The hammer drill permits
continuous adjustments of rotation of the spindle and by deactivation of the hammering action it permits drilling in such materials
as: wood, metal or plastics. The tool has been designed solely for household use. It is prohibited to use it for professional and
lucrative purposes. A correct, reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and
indications contained in this manual.
ACCESSORIES
The package provided by the manufacturer should contain (II):
- hammer drill
- SDS Plus chisel
- SDS Plus puncher
- SDS Plus drills
- additional handle
- drilling depth limiting device
- protection of the drilling chuck
TECHNICAL PARAMETERS
Parameter
Catalogue number
Nominal voltage
Nominal frequency
Nominal power
Nominal rotation
Maximum hole diameter (concrete)
Mass
Level of noise
- acoustic pressure L
± K
pA
- power L
± K
wA
Level of vibration (main handle / additional handle)
Class of insulation
Grade of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatsoever
in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
O R I G I N A L
12
GB
Unit of measurements
[V]
[Hz]
[W]
[min
]
-1
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s
2
]
I N S T R U C T I O N S
Value
79053
~230
50
800
0 - 1000
24
2,9
89,4 ± 3,0
100,4 ± 3,0
14,936 ± 1,5 / 14,898 ± 1,5
II
IP20
Publicidad
Tabla de contenido
