BGS technic BGS 8717 Manual De Instrucciones página 11

VIBRATION PRECAUTIONS
This tool vibrates during use. Repeated or long-term exposure to vibration may cause temporary or
permanent physical injury, particularly to the hands, arms and shoulders. To reduce the risk of
vibration-related injury:
1. Anyone using vibrating tools regularly or for an extended period should first be examined by a
doctor and then have regular medical check-ups to ensure medical problems are not being
caused or worsened from use. Pregnant women or people who have impaired blood circulation to
the and past hand injuries, nervous system disorders, diabetes, or Raynaud's Disease should not
use this tool. If you feel any symptoms related to vibration (such as tingling, numbness, and white
or blue fingers), seek medical advice as soon as possible.
2. Do not smoke during use. Nicotine reduces the blood supply to the hands and fingers, increasing
the risk of vibration-related injury.
3. Use tools with the lowest vibration when there is a choice.
4. Include vibration-free periods each day of work.
5. Grip tool as lightly as possible (while still keeping safe control of it). Let the tool do the work.
6. To reduce vibration, maintain tool as explained in this manual. If abnormal vibration occurs, stop
immediately.
ASSEMBLY PRECAUTIONS
1. Assemble only according to these instructions. Improper assembly can create hazards.
2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under the influence of drugs or medication.
INITIAL TOOL SET UP / ASSEMBLY
Read the important safety information section at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual
ASSEMBLY
Step1
Connect front panel (2), rear panel (3), right
panel (4R), left panel (4L) and screw up all of the
screws.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Step2
Connect the base to the four legs (7A) and (7B)
Then put screen (23) in the cabinet.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed