PROMAT SD006 Manual Del Usaurio página 13

INSTRUCTIONS FOR USE:
When the dispenser is receiving power, the LED will flash GREEN and RED to let
your know it is functioning. When in standy, the LED will flash GREEN every five
seconds.
Open front cover and press ON / OFF to turn the dispenser on or off. (ON:the LED
will flash GREEN; OFF: the LED will flash RED).
Press the button, the LED will flash GREEN once to indicate that the signal is
received, the LED will be in GREEN and the dispenser will discharge one dose when
you trip the sensors
Press the button, the LED will flash GREEN twice to indicate that
the signal is received, the LED will be in GREEN and the dispenser will
discharge two doses when you trip the sensors.
When use at first time,trip the sensors underneath with the hand 5 ~ 8 times, the
liquid can be discharged normally after the air is exhausted.
The soap dispenser is not working when the cover is opened. Please close the front
cover after adjusting the liquid discharge position.
LED:
1. When the dispenser is powered on or the dose is adjusted, LED will flash GREEN
1 or 2 times continuously.
2. The LED will flash GREEN every five seconds when in standby.
3.The GREEN LED will light up when the dispenser is discharging doses.
4. The LED will flash RED when battery is in low power; The LED will flash RED and
GREEN at same time when battery is in deep low power.
5.The LED will flash GREEN and RED alternately when the dispenser senses ab-
normalities, such as: filter clogging, power exhaustion, no liquid discharge,etc.. If
the abnormality is eliminated, shut down and restart to return to normal.
6.The LED wil flash GREEN continuously when there is an obstacle
below the dispenser, remove the obstacle to return normal.
13