PROMAT SD006 Manual Del Usaurio página 18

INSTRUCTIONS FOR CLEANING
OR REPLACING THE FILTER:
This content applies: Foam soap dispenser, it is recommended to clean or
replace filter accessories in the following cases:
1- No foam or little foam
2- Stop for one week after use
3- Used for more than 3 months
4- The LED flashes RED and GREEN continously,check if the filter is blocked
FILTER DISASSEMBLY STEPS:
1- Remove the bottle
2- Pull out the front housing of the pump
3- Remove the filter by hand , tweezers or other tools
4- Clean the dirt remaining on both ends of the filter and replace it in the original
older.
5- Assemble the front housing in place
Pump assembly
diagram
Bottle
Pump
Enlarged diagram
Pump assembly
diagram
18
Filter
assembly
Filter
Pump
front shell