ASROCK Fatal1ty 990FX Professional Serie Manual De Instrucciones página 29

2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA (SATA)
Data Cable
(Optional)
3.5mm Audio Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA
HDD power connector
Serial ATA3 Connectors
(SATA3_1_2: see p.4, No. 19)
(SATA3_3_4: see p.4, No. 18)
(SATA3_5_6: see p.4, No. 17)
USB 2.0 Headers
(9-pin USB6_7)
(see p.4 No. 26)
Fatal1ty 990FX Professional Series Motherboard
Either end of the SATA data
cable can be connected to the
SATA3 hard disk or the SATA3
connector on this motherboard.
Either end of the 3.5mm audio
cable can be connected to the
portable audio devices, such
as MP3 player and mobile
phone or the Line-in port of
your PC.
Please connect the black end
of SATA power cable to the
power connector on each drive.
Then connect the white end of
SATA power cable to the power
connect to the
power supply
connector of the power supply.
These six Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Besides six default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there
P+7
GND
are two USB 2.0 headers on
DUMMY
this motherboard. Each USB 2.0
1
GND
header can support two USB
P+6
P-6
USB PWR
2.0 ports.
29