Tabla de contenido
Publicidad
Enlaces rápidos
UNI-OPL7 Series
Outdoor Pressurized Dome Housings
Installation and Operation Instructions for the following model:
UNI-OPL7C2
UNI-OPL7T2
Note: AC 24V power supply for the camera and the heater/blower is an installer/reseller provided item.
Note: Please note that to achieve the increased depth with the aspheric design for optimal camera
lens to capsule orientation, the capsule is slightly angled around the highest section. This creates
a "line', visible to the naked eye, around the upper most section of the capsule. This "line" serves
as the geometric center line used to insure proper camera placement. It is not typically seen by
the camera. However, Sony RZ series PTZ cameras are able to tilt up above the horizon to 25°,
this wide range of tilt motion at a wide angle view may cause this line to be captured in the image.
Mounting instructions for:
SNC-RZ25
SNC-RX530
SNC-RX550
SNC-RX570
SNC-RH124
SNC-RS44
SNC-RS46
Quick Reference:
SNC-RZ25...............................Go to Steps 2-4
SNC-RX Series........................Go to Steps 5-7
SNC-RH/RS.............................Go to Steps 8-15
Outdoor Pressurized Pendant Housing w/heater & blower, clear lower dome
Outdoor Pressurized Pendant Housing w/heater & blower, tinted lower dome
Camera Installation Steps
81-IN6586
10-14-2009
Publicidad
Tabla de contenido
Resumen de contenidos para Sony UNI-OPL7 Serie
- Página 1 It is not typically seen by the camera. However, Sony RZ series PTZ cameras are able to tilt up above the horizon to 25°, this wide range of tilt motion at a wide angle view may cause this line to be captured in the image.
- Página 2 These Installation and Operating Instructions. support structure and falling, with resultant damages or injury to anyone or anything struck by the falling unit. SERVICE If technical support or service is needed, contact Sony at the following number: TECHNICAL SUPPORT 8:15AM to 7:30PM (Eastern Time)
-
Página 3: Contents Of Box
Contents of Box Contents of Box Details (1) Spacer Packet 2” ½” 1” 200mm 25mm 50mm (4) M3 x 6mm Machine Screw (4) M3 lock washers (1) 1/4 x 20 Bolt (1) 1/4 flat washer (1) 1/4 lock washer (3) 8 x 32 x 3/8" bolt (3) Cable ties (1) 4 Pin Auxiliary Connector (1) 4 Pin Power Connector... -
Página 4: Electrical Specifications
Electrical Specifications UNI-OPL7C2 Power 24VAC Class 2 Only 77 Watts at 24 VAC Heater: 50 Watts Blower: 1 Watt Camera: Approximately 25 Watts at 24 VAC* *Refer to applicable camera specs for precise consumption. English Input Connectors (Outdoor Units): (1) BNC (Analog Video) (2) Screw-Down Connectors (Power/Alarms) (1) RJ45 (Data) Tools Required: .100”... - Página 5 Camera Installation: SNC-RZ25 SNC-RZ25 SNC-RZ25 SNCRZ25 (2) 3mm screws (1) ¼”x 20 bolt lock washer SNCRZ25 MOUNTING HOLES Remove the quick release plate from the Mount the camera to the plate using the housing. appropriate pattern. • Monte la cámara fotográfica a la placa usando el •...
- Página 6 Camera Installation: SNC-RX530 / RX550 / RX570 SNC-RXSERIES SNC-RXSERIES SNCRX550 SNCRX550 (4) 3mm screws SNC RX550 MOUNTING HOLES Mount the camera to the plate using the Remove the quick release plate from the appropriate pattern. housing. • Monte la cámara fotográfica a la placa usando el •...
- Página 7 Camera Installation: SNC-RH124 / RS44 / RS46 SNC-RH124 SNC-RH124 SNC-RS44 SNC-RS44 SNC-RS46 SNC-RS46 Remove existing bracket to mount SNC-RH124 Leave four 1/2” spacers as shown. or the SNC-RS series cameras. • Retire el soporte existentes para organizar SNC-RH124 o la •...
- Página 8 • Attacchi il piatto del soffitto di SNC RH124„ ai distanziatori 1 (di 25mm) • Colleghi il controllo ed alimenti i legare alla base della macchina in alloggiamento fotografica, (vedi le istruzioni della macchina fotografica di Sony) SNC-RH124 SNC-RH124 SNC-RS44...
-
Página 9: Mounting Preparation
Mounting Preparation Wrap Teflon tape around the pipe threads Securely attach pendant pipe or the UNI-WMB1. Pull to ensure a tight seal. wiring through pipe and position grommet as shown. • Segura adjuntar colgante o de la tubería de UNI-WMB1. Tire de la •... - Página 10 Loop the lanyard over the set screw to temporarily hold housing. Make the appropriate wiring connections from the dome to the pendant. • Loop el cordón sobre el tornillo de fijación para mantener temporal- mente de la vivienda. • Hacer las conexiones de cableado de la cúpula de la pendiente.
- Página 11 Green Yellow Wires from Jumpers Dome Orange Input Add 2 jumpers if using a common power supply for the camera, heater & blower. Undo the lanyard, pull housing up and twist secure with the locking bolt and washers. • Añadir 2 jumpers si utiliza una fuente de alimentación para la cámara, calefacción y ventilador.
- Página 12 Pressurizing Instructions Air Chuck Fitting Hose Regulator Nitrogen Tank Hand tighten the screws on the dome. When pressurizing unit be sure to set the Recommended torque 12 inches/lb (1.35Nm). guage or regulator from 10-20psi (.7-1.4bar). • Al presurizar la unidad sea seguro fijar la medida o el •...
- Página 13 After purging check the housing pressure. It should be around 5psi (.34bar). • Después de purgar el cheque la presión de la cubierta. Debe estar alrededor de 5psi (34bar). • Après la purge du contrôle la pression de logement. Elle devrait être autour de 5psi (34bar).
-
Página 14: Materials Needed
How - to Clean a Dome Bubble To effectively clean your video surveillance dome bubble (acrylic or polycarbonate) from debris, follow these simple step-by-step instructions. Materials Needed • Clean, dry, pressurized air • Water • High quality soft paper towel •... -
Página 15: Replacement Parts List
Tank Valve RPFD072 24VAC Heater RPVL1798a ½" Spacers (Set of 4) RP40PCPPFD8 Connection PCB Assembly RPFD060 Main Bracket Assembly RPFD080 Blower RP40CAPPFD811 External Input Video/Power Cables RP46PKH2220 Packet Assembly-Hardware RP46PKH1120 Packet Assembly-Electrical RPVL2636 Adaptor Ring (Sony) RPVL2825 Mount Plate (Sony) - Página 16 Available Mounting Accessories UNI-WMB1 UNI-CMA1 UNI-PBU1 UNI-RMB1 UNI-PMA1 Aluminum Gooseneck Aluminum Existing Aluminum Corner Power Block Unit Parapet Mount Wall Mount Pole Mount Adaptor Mount Adaptor UNI-WMB1 UNI-PMA1 Wall Mount Pole Mount Mounting Accessories Needed: Mounting Accessories Needed: • UNI-WMB1 - Gooseneck UNI-WMB1 - Gooseneck Wall Mount Wall Mount Outdoor Pendant Housing...
- Página 17 Warranty For warranty information on this and other Sony Security Systems Products, please visit: http://pro.sony.com/bbsccms/services/files/servicesprograms/SecurityWarranty.pdf...