Dmx Linking - Chauvet DJ Data Stream 8 Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC,
50/60 Hz.
To eliminate wear and improve its lifespan, during periods of disuse completely
disconnect the product from power via breaker or by unplugging it.
Fuse Replacement
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the
exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the
Mounting Diagram
Safety Cable
Mounting Clamp
Overhead Mounting

DMX Linking

The Data Stream 8 can work with DMX controllers. Instructions for connecting and configuring this product
for DMX operation are in the User Manual. If you are not familiar with DMX or DIP-switch configuration,
download the DMX Primer from www.chauvetdj.com.
Data Stream 8 QRG Rev. 1
QUICK REFERENCE GUIDE
Safety Notes.
Mounting
Hole M12
Rack Mounting
EN
3