ASROCK H110M-G/M.2 Manual De Instrucciones página 22

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 19)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 13)
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 20)
(4-pin CHA_FAN2)
(see p.1, No. 11)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, No. 2)
20
This header is for
GND
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
Please connect the chassis
DUMMY SPEAKER
speaker to this header.
1
+5V DUMMY
Please connect fan cables
GND
FAN_VOLTAGE
to the fan connector and
FAN_SPEED
match the black wire to the
FAN_SPEED_CONTROL
ground pin.
1 2 3 4
This motherboard provides
FAN_SPEED_CONTROL
CPU_FAN_SPEED
a 4-Pin CPU fan (Quiet
FAN_VOLTAGE
GND
Fan) connector. If you plan
to connect a 3-Pin CPU
1 2 3 4 fan, please connect it to Pin
1-3.