Axis Q60 Serie Guia De Instalacion página 15

1
Cable holders
2
Multi-connector cable
3
Network cable
6. Turn the cable holders to keep the cables in place.
7. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
8. Slide the unit holders on the network camera into the slots in the mounting plate and
rotate the camera unit.
9. Install the supplied midspan, see the Installation Guide delivered with the midspan or
find it on www.axis.com
Install the camera with a drop ceiling mount
WARNING
The combined weight of the camera and ceiling mount is approximately 3200 g (7.1 lb).
Make sure that the ceiling material is strong enough to support this weight.
NO TICE NO NO TICE TICE
The ceiling tile should be 5–60 mm (3/16–2 3/8 in) thick.
1. Remove the ceiling tile in which the drop ceiling mount is to be fitted.
2. Cut a hole in the ceiling tile for the drop ceiling mount. Use the supplied template to
mark the position and cut around the template.
1
Ceiling tile
AXIS Q60 Series
15