HOW TO OPERATE
1. Press and hold + button for 3 seconds to power the unit ON and listen for the beep.
2. Press + button again to activate device.
3. Use +/- button to adjust intensity level, note there are 15 levels.
4. The device automatically powers off after 20 minutes, or press and hold - button for
3 seconds to power OFF.
Note:
• Battery will need to be replaced if the device no longer makes a beep sound or sends
any electric impulses.
• Device only works when in contact with the skin. When the device is not in contact
with the skin, the device will not activate.
• After use, always place the device into the provided carry case protecting the gel
pad after use.
• Smart Contact Detection automatically sends audible alerts when the gel pads are
not securely fixed to the skin.
• When power is on, intensity level is set to 0 for safety purposes.
Press the + button again to activate and increase intensity.
Press 3 sec to power ON;
Press 3 sec to power OFF;
decrease intensity
increase intensity