Ghibli T1 Uso Y Mantenimiento página 15

PREPARATION OF
EQUIPMENT
Control filter systems
- Release the lever (1a/1 Fig.1) and re-
move the cover (2 Fig.2) completely,
along with the fleece filter bag (3 Fig.2).
- Remove the cloth dust bag (4 Fig. 3) and
check that the cartridge filter (5 Fig. 4) is
mounted inside the unit.
- Replace the filter cloth (4 Fig.3), replace
the paper bag (3 Fig.5) on the cover (2
Fig.5) and keeping it in position refit the
cover (2 Fig.6).
- Lock the lid by the handle (1a/1 Fig.1)
NOTE:
The cover can be mounted with the output of
the tube left or right according to the needs
of the user.
Assembling of pipes
- Insert the sleeve (8 Fig.7) hose supplied
in the air intake hole (9 Fig.7).
- Attach the rigid extensions to the ergo-
nomic handle (10 Fig.8) of the hose (11
Fig.8).
- Attach to the rigid extension (11 Fig.9)
the wanted accessory (suction nozzle,
dusting brush, crevice tool, etc. ..)
Placing electric cable
(for 230 V model)
- Form a ring with the with the electric ca-
ble and attach it to the support (12 Fig.10)
positioning it as shown in figure 10.
Before recharging the batteries
(for Model 24 V)
Remove the charger and the battery from the
pack.
- Plug the cable (13 Fig.11) to the battery
(14 Fig.11).
- Connect the charger to the socket.
(15 Fig.11).
NOTE:
After connecting the power cable (15 Fig. 11)
before connecting the cable (13 Fig.11) to
the battery (14 Fig. 11) the charger WON'T
WORK.
- On the charger (15 Fig. 11) the „green"
led will blink twice (16 Fig. 11) indicating
proper functioning;; then, the red led will
turn on (17 Fig. 11) or the yellow one (18
Fig. 11) depending on the battery's condi-
tion.
- When the charger light turns greeb (16
Fig. 11) the batteries are charged.
NOTE:
Do not leave the cable (13 Fig. 11) con-
nected to the battery with the network cable
disconnected from the charger; the batteries
may discharge and could be damaged.
Installing the batteries
(for 24V model)
- Check if the switch (27 Fig.16) is on posi-
tion "0".
- Place the battery (14 Fig. 12) on the de-
vice by inserting the contacts (19 Fig. 12)
in the wholes (20 Fig. 12).
- Press the battery (14 Fig. 13) down until
you here a coupling „CLICK".
- Make sure that the lever (6 Fig. 13) is fa-
cing down and that in the slot (7 fig. 13)
appears the green color indicating the
correct coupling.
EN - 7
EN