Preparation For Operation - GRAPHITE 59G524 Manual Del Usuario

Decapador por aire caliente
Ocultar thumbs Ver también para 59G524:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
padlocks etc. Hot air gun can also be used for drying wooden elements before mechanical processing,
using heat-shrinkable sleeves, soldering and for other tasks that require heating up with the use of stream
of dry, hot air. Hot air gun is intended for amateur use only.
Use the power tool according to the manufacturer's instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Outlet nozzle
2. Air inlet holes
3. Switch
4. Wheel for smooth temperature adjustment
* Differences may appear between the device and drawing.
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Additional nozzles
2. Scraper with handle
3. Transport case
CHOOSING APPROPRIATE OUTLET NOZZLE
Depending on the needs and work performed, appropriate nozzle can be attached by sliding it onto the
outlet nozzle (1). Any additional nozzle can be fixed in the axis of hot air gun at any angle from the range of
o
o
0
to 360
(fig. A). Use of additional nozzles allows to do jobs easier and with greater accuracy.
Flat nozzle – it can protect surfaces (e.g. window glass) against overheating by directing stream of hot
air. It is especially useful for paint coating removal.
Protector nozzle – ensures uniform distribution of hot air over small areas.
Reducing nozzle – directs stream of hot air to allow working in corners and soldering.
Reflector nozzle – it is used for soldering, shaping plastic pipes, defrosting water piping and shrinking
heat-shrinkable sleeves.
Do not obstruct air intake holes (2) as it may cause power tool overheating.
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the rating plate of the hot air gun.
Hot air gun features four position switch (3) and allows to adjust temperature and air flow parameters
according to the needs for work at hand (fig. B). Set the switch to appropriate position.
Position 0 – switched off
Position I – temperature - 25
Position II – temperature range - 80 - 600
Position III – temperature range - 80 - 600
- 4 pcs
- 1 pce
- 1 pce

PREPARATION FOR OPERATION

OPERATION / SETTINGS
0
C
0
C
0
C
13

Publicidad

Tabla de contenido
loading

Tabla de contenido