Publicidad
Idiomas disponibles
Idiomas disponibles
www.digisportinstruments.com
INSTRUCTION MANUAL
SCOREBOARD DT700
FEATURES:
- 24 hour clock display
- Count up timer with range to 9 hr.
59 min. 59 sec.
- Countdown timer with loud beep
- Large 4 inch LCD digits for
viewing from as far away as 150
feet
- RF remote control – no cords
required
- Displays scores of two teams up
to a maximum score of 199
- Powered by AC adapter (included)
or batteries (four D size – not
included)
- Wall mounted or free standing
- 16 different RF channels,
user-adjustable
to
another
channel to avoid interference
wit nearby units
LIST OF ACCESSORIES:
- Scoreboard
- Remote control with four AAA
batteries
- Tripod rod
- AC adapter (For indoor use only)
- Instruction manual
HOW TO OPEN NAME PLATE
DOORS:
Use a suitable screwdriver to open
the side doors as shown in Figure
2. Do this carefully
to not damage the plastic side
doors. This will allow the removal or
insertion of the nameplates
and ads.
MOUNTING THE SCOREBOARD:
The scoreboard can be fix on the
wall with 2 screws hooked into the
eyelets on the back top housing.
Make sure the screws are securely
fixed into the wall. The scoreboard
can also stand-alone on the floor or
on a table using the tripod rod
secured
to
the
back
of
scoreboard as shown in figure 3.
POWER UP:
For AC connection, use only the AC
adapter (9V) supplied with the unit.
Check if the power rating indicated
on the adapter is the same as the
AC power supplied in your location.
Plug the adapter into the socket on
the right side of the scoreboard as
shown in Figure 3. The digits will
light up automatically and be ready
for
setting.
When AC power is not available,
insert four D size batteries into the
battery compartment on the back of
the scoreboard as shown in Figure
4. When using battery power, the
ON/OFF SWITCH should be used
to turn the scoreboard on and off. If
the
batteries
are
left
in
scoreboard during AC operation,
they will be use as a back-up in the
event of AC power interruption.
The batteries for the remote control
can be inserted as shown in Figure
5.
TIME SETTING:
From the Time Display Mode as
shown in Figure 6. Press and hold
<MODE> for 3 seconds to go to the
Time Setting Mode as shown in
Figure 7. In this mode press <SET>
once for time setting and the time
digits will blink. Adjust the minute
by using the <+/- TEAM 2> and the
hour by using the <+/-TEAM 1>.
When time is set, press <SET> to
exit to the Time Display Mode.
COUNT UP MODE:
When the scoreboard is in the Time
Display Mode, press and hold
<MODE> 3 seconds and repeat this
action once more. It will enter in the
Count Up Mode showing "C UP" as
shown in Figure 8. Press <SET>
once
and
0:00:00
will
displayed. Press <START/STOP>
to start and press again to stop the
count up timer. After timing is
stopped, press and hold <SET> 3
seconds to reset to zero.
the
the
be
Publicidad
