Craftsman 580.325610 Instrucciones De Uso página 7

Your C raftsman generator requires some assembly and is
ready f oruse only after i t hasbeen p roperly servbed w iththe
recommended oiland fuel.
tf youhave anyprobbms w iththeassemMy ofyour
generator,
please call the generater heb]ine at
1-80e-222-3136.
Unpacking the Generater
1. Set the carton on a rigid fiat surface.
2. Removeeverything from carton except generator.
3. Open carton completely by cutting each corner from top
to bottom.
4. Leavegenerator on carton to install wheel kit.
Carten Centents
Check alI contents against those listed below:
o Main unit
o Engineoii
o Operator's manuai
Wheel kit
o Adapter cord set
If any parts are missing or damaged, call the generator
helpline at 1=800=222=3136.
nstall Wheel Kit
NOTE:Wheel kit is not intended for over-the-road use. DO
NOTtow this unit with a motorized vehicte.
You wiii need the following tools to install these
components:
o 13ram wrench
o Socket wrench with a 13ram socket
o Pliers
o Safety gtasses
Install the Wheel }(it as Folbws:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Placea wheel (B) on each side as shown.
4. Mace a washer (C) on axie and then place an e-ring (g)
in axle groove.
5. InstalI e-ring with pliers, squeezing from top of e-ring to
bottom of axle.
CAUTION
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Alwaysweareyeprotection wheninstalling/removing e -rings
6. Repeatsteps 4 and 5 to secure second wheei.
7. Tip generator so that engine side is down.
8. Line up holes in support leg (E) with holes in generator
frame.
9. Attach support ieg using two short capscrews (MS x
16 ram) (F) and two iocking hex nuts (G). Tighten with
a 13 mm socket and wrench.
10. Return generator to normat operating position (resting
on wheels and support leg).