Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Sideburner
[]
Loosenside burner in side shelf. (B). To loosen, unscrew and remove two front screws holding
sideburner in place. (A). Note: Do not loosen eJectrode screw.
[]
Removethe 2 pre-instalied screws from the valve stem and set them aside. (C)
[]
insert valve stem through hole in fascia. (D) Attach bezeJ to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up (E).
[]
Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (F)
[]
Pushcontrol knob onto sideburner valve stem. (G)
[]
Reattach sideburner to sideburner sheJfwith the 2 previously removed screws. Replace sideburner
grate. (H)
[]
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module.(I)
[]
Unscrew igniter cap from control panel. Insert (1)AAA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel (J)
16198-40700219
• 23
Publicidad
Tabla de contenido
