Max Care Routine; Deactivating Or Activating The Easy-Start Feature - Philips Sonicare FlexCare HX6911/50 Manual De Instrucciones

Brushing routines
Go Care routine
1-minute brushing cycle in the Clean mode, for a quick clean. You hear
the Quadpacer signal at 15-second intervals.

Max Care routine

3-minute brushing cycle that combines the Clean and Massage modes in
one routine for a thorough mouth clean. There are 30 seconds of Clean
mode and 15 seconds of Massage mode for each of the 4 sections of
your mouth. You will hear the Quadpacer signal at 45 second intervals.
Note: When Sonicare is used in clinical studies, the default
2-minute Clean mode must be selected. The handle should
be fully charged. Deactivate the Easy-start feature and for
areas where excess staining occurs, an additional 30 seconds
of brushing time can be spent to assist with stain removal.
Features
Easy-start
- This Sonicare model comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the first 14 brushings
to let you get used to brushing with the Sonicare.
Note: Each of the first 14 brushings must be at least 1 minute in length to
properly move through the Easy-start ramp-up cycle properly.

Deactivating or activating the Easy-start feature

1 Attach your brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the power on/off button for 5 seconds. You hear
1 beep to indicate that the Easy-start feature has been deactivated.
- To activate Easy-start:
Press and hold the power on/off button for 5 seconds. You hear
2 beeps to indicate that the Easy-start feature has been activated.
ENGLISH
13