Blade Replacement - Black+Decker LE750 Manual De Instrucciones

English
Blade (Fig. I)

DANGER:
come to complete stop.
The blade 13 , two spacers
conical washer should be attached to your edger in the
order shown. Please check that the blade has been properly
mounted before using your edger. The edger blade has two
wear indicators that show when blade needs to be replaced.
When the blade wears to the small hole at each end of the
blade it will give only 1/4 " (6 mm) depth of cut and should
be replaced.
nOTE: To increase blade life, keep initial cutting depth at
minimum and increase depth setting as blade wears.

Blade Replacement


DANGER:
come to complete stop.

DANGER:
the switch is released.
1. Loosen the hex head nut
on the outer spacer 14
between the blade 13
the blade from turning.
2. Ensure inner spacer is on shaft—"flats" in spacer hole
must engage with "flats" on shaft.
3. Holding the spacer in place, put the blade on the shaft,
as shown (Figure I).
4. Hold the blade against the spacer and install the outer
spacer, again aligning the flats in the spacer with the
flats on the shaft.
5. Install the hex head nut and conical washer, then
tighten with a wrench.
nOTE: Replace hex head nut and conical washer only
with identical replacement part.
Hex nut with conical washer
Écrou Hexagonal muni d'une rondelle conique
Tuerca hexagonal con roldana conica
Fig. I
14
6
Unplug tool. Wait for blade to
14 and hex head nut 15
Unplug tool. Wait for blade to
Blade rotates momentarily after
15 (9/16"). Use a 1" wrench
, or a 2" x 4 " wood block
and guard if necessary to hold
15
13
OPERATION

WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
with
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Proper Hand Position (Fig. J)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 8 and one hand on the auxilliary handle
Fig. J
Switch (Fig. A)
To turn tool ON, squeeze the trigger switch
has been designed so that it is very easy to hold in the ON
position. To turn tool OFF, release the trigger.
nOTE: The edger is a major appliance and should not be
operated simultaneously with other major appliances on
the same household circuit.
Usage
1. Set cut depth at 1" and set edge guide to
the down position, refer to Assembly and
Adjustments Instructions.
2. Before starting the edger, line up the tool so the edge
guide rests against the edge of the paved surface.
Both rear wheels should be on the paved surface
when edging.
nOTE: When there is heavy overgrowth of grass over the
paved surface it may drag on the guard. An initial cut may
be required with the edger on the grass side. This will
require lifting up the edge guide and may require reducing
the depth of cut (refer to To Change Position of the Edge
Guide instructions).
To reduce the risk of
To reduce the risk of serious
To reduce the risk of serious
8
6
6 .
7 . The trigger