Axxess ASWC-1 Instrucciones De Instalación

ASWC-1
INSTALLATION INSTRUCTIONS
Axxess Steering Wheel Control Interface
www.AxxessInterfaces.com
U.S. PATENT # 8,214,105 8,014,920 8,285,446 8,527,147
BEFORE YOU BEGIN
From the Axxess website, www.AxxessInterfaces.com, click on the link titled "VEHICLE FIT
GUIDE AND ASWC-1 INSTRUCTIONS", which is located on the top set of tabs. Once you have
input your vehicle information, click on the "SUBMIT" button. This will take you to a page
where you will be notified if your vehicle will work or not with the interface. If the interface is
compatible, there will be a link under the green bar titled "ASWC-1 Installation Instructions".
Click on this link to open the PDF document for your specific vehicle. Print this document so
you will have it with you in the vehicle during the install.
INTERFACE COMPONENTS
• ASWC-1 Interface • 12-pin harness with male 3.5mm connecter
• Female 3.5mm connector with Brown and Brown/White wires
Note: Though we have done extensive research, testing, and verifying that the steering wheel
control wires of the vehicles listed are correct. It is still the installers responsibility to verify
that the steering wheel control wires are truly correct. If a discrepancy is found, please notify
our Tech Department at 1-800-253-TECH, or techsupport@metra-autosound.com.
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before cycling the ignition. Also, do not remove the factory radio
with the key in the on position, or while the vehicle is running.
Integrate • AxxessInterfaces.com
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 11/27/17