Delton RA Guia De Inicio Rapido página 5

ATTENTION: DO NOT INSTALL THE CONTROL UNIT BEFORE
1. Introduction.
The control units "RA,RA1,RA1/BJ,RA1 POWER are projected to operate roller shutters and sun shades. These have a radio receiver for remote
controlling through the transmitter (Tx typ B.RO). In order to simplfy the installation, the power supply is 230 Vac and through three cables it is possi-
ble to connect motors with power up to 250W ( 500W for the RA1 Power) with internal limit switches. It is furhermore possible to connect to the control
units RA1, RA1/BJ and RA1 Power two push-buttons for the opening and closing function.
2. Configuration.
Learn button
Radio module
Led: Present
only at RA and
RA1.
Commands clamp: Present
only at RA1,RA1/BJ,RA1
Power.
3. Electrical connections
4. Learnings
4.1 Memorisation of the first transmitter
Once the system is supplied with power the control unit automatically enters to the learning mode awaiting the signal of a transmitter. Once received a
signal the unit automatically assigns the opposite function to the second button of the transmitter (if present) and turns to normal functioning mode. By
the next start the unit gives two short acustic signals or led-blinks to indicate that at least one transmitter was memorised.
4.2 Subsequent memorisation of transmitters with the learn button of the control unit.
Press once the
learn button
LED LED
LED LED
a a a a b b b b
LED LED LED LED
c c c c d d d d
e e e e
4.3 Subsequent memorisation of transmitters with the hidden key of a memorised transmitter
Press the hidden
button "e"
a a a a b b b b
LED LED
LED LED
c c c c d d d d
e e e e
Attention: Do not use this procedure in presence of two or more control units close to each other. Because each control unit
nearby could be affected. We recommend to cut the power supply to the non interested control units.
6-1622135 REV.4 04/09/2006
RA-RA1-RA1/BJ-RA1 Power
Control unit for one motor- roller shutters
READING THE INSTRUCTIONS!
J1 J2
Memorisation:
1. Press the learn button on the control unit. The control unit gives a series of acustic (buzzer) or visual (led)
signals.
2. Press the button "a" of the transmitter. The unit automatically stores the button "b" ( "a" controls opening
and "b" closing). Once both buttons are memorised the unit turns to normal operating mode.
Memorisation:
1. Press the hidden key "e" on a previously memorized transmitter. The control unit gives a series of acustic
(buzzer) or visual (led) signals. This operation has the same result as pressing the learn button on the
control unit but without having to open the control unit.
2. Repeat point 2 of paragraph 4.2.
ITA ENG
Transformer
Buzzer and jumper:
Present only at RA1/BJ
and RA1 Power
FRA ESP DEU POR
Relays:
each 5 A for the
•
RA,RA1 and RA1/BJ
each 16 A for RA1
•
Power
1/2