Recall Function
After switching off the hob (0/I), it is possible to recall the last settings.
• cooking stages of all cooking zones (power)
• minutes and seconds of programmed cooking zone-related timers
• Keep warm function
The recall procedure is following:
• Press the key [0/I]
• Then simultaneously press the 2 zones back in less than 6 seconds.
The previous settings are again active.
Bridge Function
This function allows to use the 2 cooking zones at same time with the same features as a single
cooking zone. Booster function isn't allowed.
Action
Activate the hob
Activate the bridge
Increase bridge
Stop the bridge
« Keep warm » Function
This function allows to reach and maintain automatically a temperature of 70°C.
This will avoid liquids overflowing and fast burning at the bottom of the pan.
• To engage, to start the function « Keep warm » :
Action
Zone selection
To engage
To stop
This function can be started independently on all the heating zones.
When the pan leaves the cooking zone of the "Keep warm" function remains active during
approximately 10 minutes.
The maximum duration of keeping warm is 2 hours.
Control panel
Press display [
]
Press on the 2 cooking zones
Slide on the "SLIDER "
[ 1 to 9 ] or display [ keep warm ]
Press on the 2 cooking zones
Control panel
press display [ 0 ] selected
press [ Keep warm ] on the "SLIDER"
press on display [ U ] selected
slide on the "SLIDER"
13
Display
[ 0 ] or [ H ] on the
4 displays
[ 0 ] appears on the front
zone
[ ∏ ] on the rear zone.
[ 1 to 9 ] or [ U ]
[ 0 ] or [ H ] on the 2
zones
Display
[ 0 ] to [ 9 ] or [ H ]
[ U ]
[ U ]
[ 0 ] to [ 9 ] or [ H ]