CAUTION! Misuse can cause electrical shock
and injury.
• DO NOT use as work surface. NO CUTTING, NO
DRILLING, NO HAMMERING.
• Use with momentary loads only. DO NOT place
ladders, scaffolds or any type of structure on the
protector.
• Avoid concentrated loads.
• Use only on a stable surface. Inclined surfaces,
slippery surfaces and broken ground can cause
injury.
• This protector can be a trip hazard to pedestrian
traffic if they are unaware of its presence.
• Keep the Drop Over Cable Protector clean and bright.
• Keep various services, communications, fluids and
power separated. Limit a protector to one service
type.
• Polyurethane is attacked by some chemicals. Always
test a small amount for chemical compatibility before
using and follow maintenance procedure.
• Vehicular traffic must pass over the protector slowly
and with caution.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
MAINTENANCE
1-800-295-5510
uline.com
• Store in a clean dry area.
• Inspect protector for damage and replace it if
damaged.
• Remove any foreign materials, solids and liquids.
• Keep clean by using a detergent and water solution.
0421 IH-8490