Introduction; Kit Contents; Fitting - Parrot CK3000 EVOLUTION Manual Del Usuario

INTRODUCTION

The Bluetooth wireless technology enables voice and data to be sent via a short-distance radio
link. It allows several electronic devices to communicate with each other, particularly phones
and hands-free kits.
Parrot draws on its long years of experience in the Bluetooth technology and signal
processing to offer you innovative hands-free kits.
Thank you for purchasing this steering wheel control interface designed for the Parrot CK3100
LCD and Parrot CK3000 EVOLUTION hands-free kits. The Parrot MULTICAN interface enables you
to connect your vehicle's steering wheel controls (SWC) to your Parrot hands-free kit. With this
interface, you will be able to make phone calls via the steering wheel controls while keeping
your hands on the wheel.

KIT CONTENTS

• Installation cables
- Power supply cable for the interface
- Parrot CK3000 EVOLUTION control keypad adapter
(available depending on your product's model)
- Parrot CK3100 LCD screen adapter
(available depending on your product's model)
- Bullet terminal female
• Directions for use

FITTING

This fitting guide only describes the procedure for fitting the Parrot MULTICAN steering wheel
control interface. Do not hesitate to refer to the directions for use supplied with your hands-free
kit for further information on the fitting procedure. We would advise our customers to have the
interface fitted by a professional.
Note : In the rest of this guide, the abbreviation «SWC» will be used to replace the term
«steering wheel controls».
Fitting the Steering Wheel Control (SWC) Interface:
The power supply for the Parrot MULTICAN interface is taken from the power cable of the Parrot
hands-free kit.
It is important to follow the colour code of the power cable wires:
- The red wire of the kit's cable corresponds to the permanent 12V supply
- The orange wire corresponds to the ignition 12V (usually supplied by Parrot
Multican)
- The black wire is for ground
- The yellow wire corresponds to the Parrot mute output
On some vehicles, the 12V power wires may be reversed, in which case you must reverse the
red and orange wires of the hands-free kit's power supply. This can easily be done by reversing
the two fuse holders on the kit's power cable.
Ensure that the orange wire is used for the ignition +12V. Otherwise, you might run down the
vehicle's battery. You must therefore connect the orange power wire to the fuse box or another
ignition power source.