Vacation Mode; Error Messages - Raychem QuickStat-TC Manual De Instalación Y Funcionamiento

Vacation Mode

In this mode, the QuickStat-TC is set to the Vacation setpoint
temperature and will override all programming until Vacation mode is
disabled. To place the QuickStat-TC in this mode:
1. Press the button, and the
2. To disable Vacation mode, press the
mode to Automatic or Manual
To reset the QuickStat-TC to factory default settings:
3. Turn the thermostat to Off.
4. Press the up button and switch the thermostat On.
5. After the thermostat setup is completed, release the up button

Error Messages

The measured temperature is below the thermostat's display
range. Heating is activated.
The measured temperature is above the thermostat's display
range. Heating is deactivated.
Verify the floor sensor connection to the thermostat.
icon appears on the display.
Mode/Ret button to change the
.
.
QuickStat-TC Installation & Operation Manual
5
400-115-052