Safety Regulations - EINHELL GC-EM 1536 Manual De Instrucciones Original

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 12)
1 = Read the directions for use before operating
the equipment
2 = Keep all other persons away from the danger
zone.
3 = Caution! -Sharp blades- Before carrying out
any maintenance work or if you damage the
cable, pull the plug out of the socket.
4 = Caution: Keep the power cable away from the
cutters!
General safety regulations for this electrical
tool
This equipment is not allowed to be used by
children. Children should be supervised so that
they do not play with the equipment. Children
are not allowed to carry out the cleaning or
maintenance. This equipment is not allowed
to be used by people with limited physical,
sensory or mental capacities or by those with
insuffi cient knowledge or experience unless they
are supervised or instructed by a person who is
responsible for them.
Safety instructions for hand mower
•
Before use, check the mains cable and
extension cable for signs of damage and
aging.
•
If the cable is damaged during operation,
Anl_SA_GC_EM_1536.indb 21 Anl_SA_GC_EM_1536.indb 21
GB
disconnect it immediately from the power
supply.
•
Check the machine for signs of damage
before use. Repairs may only be carried out
by our service workshop. If unusual vibrations
occur during use, switch the machine off
immediately and pull the plug. Check the
cutters and clean them if necessary. If the
machine continues to vibrate, switch it off,
disconnect it from the mains supply and send
it to our service workshop.
•
The machine must not be tipped whilst it is
being started. Both hands must be on the
handle when you start the machine.
•
Worn parts may only be replaced by our
service workshop. If necessary contact the
service address provided.
WARNINGS
•
Do not use the mower if the connection cable
is damaged or worn.
•
Do not use a damaged cable to connect
the machine to the mains supply and do not
touch a damaged cable whilst it is connected
to the mains. A damaged cable can result in
contact with live parts.
•
Do not touch the cutters until the machine has
been disconnected from the mains and the
cutters have reached a complete standstill.
•
Keep extension cables away from the cutters.
The cutters can damage the cables and result
in contact with live parts.
•
Break the connection with the mains supply
(in other words pull the plug out of the
socket):
- whenever you leave the machine
unattended;
- before released a blocked cutter;
- before inspecting or cleaning and before
working on the machine;
- if a foreign body has been struck;
- whenever the machine starts to vibrate
oddly.
•
Carefully read the instructions for how to
operate the machine safely.
•
We recommend that the machine is only
connected to a power supply protected by
means of an earth-leakage circuit breaker
(RCD) with a maximum trip current of 30 mA.
- 21 -
05.07.2018 08:37:28 05.07.2018 08:37:28