Putting Into Use - Harper TFR2916 Manual Del Usuario

cooled to avoid scald.
Before first use, please check carefully if all the parts of the
◆
appliance are in good condition. If not, please contact the supplier or
manufacturer. Never use this appliance if it is not in good condition
or attempt to repair the malfunctioning appliance.
The appliance must be earthed.
◆
The deep fryer is equipped with an adjustable thermostat, so that the
temperature can be adapted to the food being fried. The optimal and
safe use of the deep fryer requires that the use instructions be read
carefully.
The fryer must be connected to a properly installed 230 V, 50 Hz socket
with earthing protection.
Introducing the oil or fat
1.
Open the top lid.
2.
Lift the basket using the handle.
3.
Place approximately 0.75 liters of oil or 0.6 kg of hard fat into the
fryer body (the level must always be between the two marks on the
oil container wall).
4.
If you use blocks of fat, cut them into pieces before placing them in
the body.
5.
Set switch of the temperature controller to 140
light comes on). To melt the fat needs roughly 8 minutes.
Introduction
Connection

Putting into use

14
(the red Indicator