Tripp-Lite MODBUSCARDSV Guia De Instalacion página 3

Confi guration
There are eight DIP switches on SW1 and a combined eight DIP switches on SW2 and SW3. When the DIP switch is pushed to
the ON (down) position, it is set to "1". If the DIP switch is in the OFF (up) position, it is set to "0".
Machine ID Confi guration (SW1)
Use SW1 to set the machine ID. The MODBUSCARDSV ID is set to 0x01 as shown in the diagram below. Refer to the
Appendix in this manual for detailed ID numbers and SW1 settings.
Communication Format Confi guration (SW2)
DIP switches 1 - 4 are used to confi gure the card's communication settings.
Note: DIP switch 5 is unused for this confi guration.
19-03-386-93397E.indb 3 19-03-386-93397E.indb 3
Function DIP Setting
Baud Rate # 1 # 2
OFF OFF
ON OFF
OFF ON
ON ON
Parity Check # 3 # 4
OFF OFF
OFF ON
ON OFF
ON ON
3
Meaning
2400 bps
4800 bps
9600 bps
19200 bps (Default)
Even parity
Odd parity
No parity check, 1 stop bits
(Default)
No parity check, 2 stop bits
9/12/2019 10:41:53 AM 9/12/2019 10:41:53 AM