Tripp-Lite B110-SP-CAT-OD El Manual Del Propietario página 7

4. Repeat Steps 1-3 for the equipment (ex: PoE camera) side
Note: To achieve the best protection performance, the Cat5e/6/6a
patch cable between the equipment end of the B110-SP-CAT-OD surge
protector and the equipment to be protected must not exceed 300 ft.
5. Once both bare wires are crimped, connect the newly
Note: Ensure the cable end of the PCBA is facing the side with the
slit and the equipment end facing the other. Make sure you connect
your source to the cable end, and your PoE-compliant device to the
equipment end.
19-11-220-933B57-BOOK.indb 7 19-11-220-933B57-BOOK.indb 7
Installation
of the enclosure without the addition of a grounding wire.
crimped RJ45 cables to the PCBA, then secure the PCBA
board to the enclosure using the included mounting screws.
Lastly, attach the grounding wire to the available screw on
the PCBA board.
7
2/5/2020 1:28:51 PM 2/5/2020 1:28:51 PM