Olivia Garden Ceramic+ion CI-FLT1 Manual Del Usuario página 2

WARNING: KEEP AWAY FROM WATER
Any appliance is electrically live even when
the switch is OFF. To reduce the risk of
death or injury by electrical shock:
1. Do not use your flat iron while
bathing, showering, or in any
other application where it could
come into contact with water or other liquid.
2. Do not place or store your flat iron where it
can fall or be pulled into a tub or sink.
3. Do not place into water or other liquid.
4. Do not spray or apply wet styling aids
directly onto your flat iron.
5. If your flat iron falls into water, unplug it
immediately. Do NOT reach into water.
6. Always unplug your flat iron immediately
after using.
WARNING: HOT SURFACES
This iron gets extremely hot. Please use caution
when handling. To reduce the risk of burns,
fire or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Use this appliance only for its intended
use as described in this manual. Do not use
attachments not recommended by manufacturer.
3. Keep the cord away from heated surfaces.
4. Never place objects on the iron plates. The
plates get extremely hot and objects may
melt or damage the plates.
5. Do not use outdoors or operate where
aerosol products are being used or where
oxygen is being administered.
6. This unit is hot when in use. Do not let eyes
or skin touch heated surfaces.
7. Do not place the heated unit directly on any
surface (unless it is high heat resistant) while
it is hot or still plugged in.
Operating Instructions
This appliance is for salon or household use, and
may be plugged into your AC electrical outlet
(100-240VAC 50/60Hz). If you are traveling, use
the appropriate adapter to plug in your electrical
outlet. Your flat iron will then automatically adjust
itself to the adequate voltage and function normally.
IMPORTANT
Keep heated surfaces away from contact with all
skin areas and eyes. Do not touch straightening
plates with your fingertips. For shorter hair, place
a thin plastic comb between scalp and iron to
avoid touching scalp. Test small section of hair
before styling whole head.
1. Place the iron on a smooth and flat surface,
ideally on your heat resistant mat, and then
plug into outlet.
2. Switch the ON/OFF switch to ON.
3. Allow 1 minute (or less) for flat iron to reach
the maximum temperature.
4. Work with hair sections that are no more
than 1" wide and 1⁄4" thick.