Mountinga Nd Wiring The Safety Sensors - Craftsman 139.53924 Manual Del Propietário

MOUNTING
A ND WIRING THE SAFETY SENSORS
• Slide a 1/4"-20xl/2" carriage bolt head into the slot
on each sensor. Use wing nuts to fasten sensors
to brackets, with lenses pointing toward each other
across the door. Be sure the lens is not obstructed
by a bracket extension (see Figure 5).
• Finger tighten the wing nuts.
Recommended Wire Routing
1. Using insulated staples, run the wires from both
sensors to the rail at the door header
(see Figure 6).
2. Cross and twist the two wires where they meet
the rail (see Figure 6, Illustration A). Run the wires
inside the channels at the top of the rail, along
each side, to the motor unit. Do not use the lower
(trolley) channels. Use a screwdriver tip to tuck
the wires snugly into the channels.
NOTE: If your access door is near the garage
door, you may choose to install the door control at
this time and run the door control wire along the
rail with the sensor wires. Use one rail channel for
the door control wire and the other channel for
both sensor wires. If you choose this option, follow
instructions 1-3 on page 20 now.
3. Pull wires taut across the top of the chassis and
insert into the opening above the terminal block
(see Figure 6, Illustration B). You will complete the
wiring in Installation Step 7.
Figure 6
Figure 5
CarriageBolt---_
1/4"-20xl/2"
Len!
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolt
1/4"-20xl/2"
Wing Nut
1/4"-20
Staples
Header
-- Wall --
Sensor
Wire
Twist
Wires
Sensor
Wire
Header
Bracket
1. Run wires from sensors
to end of rail at the door
header. Cress & twist here
to help contain wires in
channels on top of rail ,q.
2. Run wires aUong channeUs
to motor unit= Use screwdrive _ Bell Wire
blade to tusk snugly into
channels.
Rail
Channel
B
3. Pull wires taut across
top of chassis and
insert into opening
above terminal block.
Sensor Invisible Light Beam
Protection Area
Sensor
17