Using The Wall-Mounted Door Control; The Plug-In Light Control - Craftsman 139.53924 Manual Del Propietário

Using the Wall.Mounted
Door Control
THE MOTION DETECTING CONTROL CONSOLE
Press the lighted push button to
open or close the door. Press
Push
Bar
again to reverse the door during
the closing cycle or to stop the Lock
door while it's opening. Button
Light
This door control contains a
Button
motion detector that will
automatically turn on the light
when it detects a person entering the garage. This
feature can be easily turned off for extended work
light use.
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button
until the light blinks (about 10 seconds). A single
blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat
again for a 3-1/2 minute interval, etc., up to a
maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you first disable the motion sensor.
See Automatic Light Feature, below.
Automatic Light Feature: The opener light will turn
on automatically when a person enters the garage.
When a person walks in front of the door control, the
light will come on for five minutes, then shut off. This
feature works by detecting body heat and may not
work in temperatures around 100°R
To disable this feature, slide the Detector Switch on
the right side of the door control down (off).
We recommend that you disable the motion sensor
when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensors range.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will
open and close from the Door Control, the Outdoor
Key Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing.
The Lock feature will also turn off whenever the
"learn" button on the motor unit panel is activated.
Additional feature when used with the 3-Function
hand-heM remote
To control the opener lights: _-_
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the door
control.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release all buttons.
THE PLUG-IN LIGHT CONTROL UghtContro_
Actuator
Programming the control
The Plug-In Light Control receiver
needs to learn the hand-held Antenna
remote code. Follow the
instructions below: ....
Learn Learn
Button Indicator Light
1. Plug the light control into a
120VAC polarized outlet. The plug contacts are
designed for polarized outlets only.
2. Press and release the "learn" button on the Plug-
In Light Control. The learn indicator light will glow
steadily for 30 seconds.
3. Within 30 seconds, press and hold the button on
the hand-held remote.
4. Release the remote control push button. Code
setting is now complete.
The remote control push button
must be held down until the
receiver indicator light flashes for
the light control to learn the select a
remote control's code.
push button
31