Measupro IRT20 Manual Del Usuario página 2

This infrared thermometer is used for measuring the temperature of an
object's surface safely and quickly. This is applicable for various hot,
hazardous, or hard-to reach objects with no direct contact necessary.
This unit consists of Optics, Temperature Sensor Signal Amplifier,
Processing circuit and LCD display. The Optics collect the infrared
energy emitted by objects and focus it onto the sensor. Then the sensor
translates the energy into an electrical signal.
To avoid any personal harm or damage, pay attention to the following:
1. Before you use this unit, check on the plastic housing carefully. If
there is any damage, do not use it.
2. Do not point the laser directly in the eye or indirectly off reflective surfaces.
3. Do not use this unit in the environment of explosive gas, steam, or dust.
To avoid damage to the unit or target, avoid the following situations:
1. EMF -electro-magnetic fields from arc welders, induction heaters.
2. Thermal Shock - caused by large or abrupt ambient temperature
changes. Allow 30 minutes for the unit to stabilize before use.
3. Do not leave the unit on or near objects of high temperatures.
1. When you take a measurement, pay attention to the distance and
spot size. As the distance (D) from the target surface increases, the
spot size (S) of the
area measured by the
unit becomes larger.
The distance to spot
size of the unit is 12:1
*This unit is equipped
with a laser, which is
used for aiming.
2. Field of view:
Make sure the target is larger than the unit's spot size. The smaller
the target the closer the distance. When accuracy is critical, make
sure the target is at least twice as large as the spot size.
Most organic materials and painted or oxidized surfaces have an
emissivity of 0.95 (pre-set in the unit). Inaccurate readings will result
from measuring shiny or polished metal surfaces. To prevent this, cover
the target surface with masking tape or flat black paint. Measure the tape
or painted surface when the tape or paint reach the same temperature
as the material beneath.
2
Introduction
Warnings
Distance to Spot Size
D:S=12:1
Emissivity
38mm@ 75mm@ 132mm@
300m m 900m m 1500m m
1.5" @ 3.0" @
36 "
12"
Figure 1
Product Manual
5.3" @
60 "