Operating The Juicer - COURANT CJP-4035 Guia Del Usuario

Operating the Juicer

The appliance will only function if all parts have been properly assembled. Proper
assembly unlocks the microswitch and allows the juicer to run.
1. Slice food into pieces just small enough to fit into the feeding tube (
blade inside the feeding tube that will cut food in half as food is inserted.
13
2. Set the pulp (
spouts. Make sure the juice spout is open.
3. Switch the appliance on by turning the control knob (
Do not use the "R" position. This setting is for when the auger is stuck.
4. Place prepared fruits or vegetables into the feeding tube. Use the pusher to gently
press them down if they do not fall all the way in. Do not press hard on the push-
er, as this could affect the quality of the juice or cause blockage in the appliance.
Never reach into the feeding tube or place any items inside of it except for
the pusher or recommended food products.
5. The juice will flow directly into the juice jug (
the pulp container (
6. After you have processed all ingredients and the juice flow has stopped, switch the
appliance off and wait until the motor and all moving parts have stopped.
7. Empty the pulp and juice containers as needed.
8. Turn the appliance off, unplug it and then clean it using the instructions in this
guide
) and juice containers (
13
).
14
) under the pulp (
12
) to the "ON" position.
14
), and the pulp will be collected in
9
2
). There is a
7 8
) and juice ( )