Troubleshooting - METRO PROFESSIONAL GSC2360 Manual De Instrucciones

• Clean the shelves thoroughly with a soft damp
cloth and a little mild detergent at least once a
month. Dry with a soft dry cloth.
• To ensure a trouble-free performance and to
avoid excessive electricity consumption, clean
the condenser every three months using a
vacuum hose. When using the appliance under
special conditions, clean the condenser more
often.
• Clean the gaskets and seals with a dry and soft
cloth. Check them for debris to ensure the door
always closes properly.
• The appliance may only be used again or stored
after it is dried completely.
Defrosting
• To defrost the appliance, remove all foodstuffs
from it, set the thermostat to "OFF" and unplug
the appliance.
• Let the ice in the appliance interior melt and
discard the water afterwards.
Storage
• Before storing, remove all foodstuffs from
the appliance, disconnect it from the supply
and clean the appliance and its accessories
thoroughly.
• Store the appliance in a dry, protected
environment, preferably at room temperature.
• To protect the appliance from dust, cover it
with a cloth that allows air circulation inside the
appliance.

4. Troubleshooting

WARNING!
• In case of failures or malfunctions, always
unplug the appliance immediately.
• Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be
performed by an authorized service center or a
similarly qualified specialist.
• Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
Possible
Problem
cause
Power plug
not connected
to electrical
outlet.
Appliance
does not
operate.
Supply cord is
damaged.
Thermostat
is not set
correctly.
Appliance is
located near
heat sources.
Stored
beverages or
other objects
prevent
Appliance
proper closing
does not
of door.
achieve
required
Cooling
temperature. compartment
overloaded,
filled with hot
beverages or
filled in a way
that prevents
proper air
circulation.
Door is
opened and
closed too
often.
Back of
appliance is
placed too
near to the
wall or to
other objects.
Appliance is
very noisy.
Appliance not
in a stable
position.
Normal
Condensation phenomenon
on outside of in hot and
appliance. humid
environments.
- 7 -
Solution
Connect power
GB
plug to a suitable
electrical outlet.
Plug it in tightly.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
Set temperature
with thermostat as
described in this
manual.
Move appliance
well away from heat
sources.
Reorder contents
of cooling
compartment or
remove several
items to allow door
to close.
Remove several
items, remove
hot beverages or
reorder contents
of cooling
compartment to
allow air circulation.
Keep door closed
for a while.
Keep a minimum
distance of 1m to
wall or other objects.
Bring appliance into
a stable position by
adjusting the legs.
Make sure that all
legs are firmly on
the ground.
Wipe appliance with
a dry and soft cloth.