Preventative Maintenance - K-Tool KTI63136 El Manual Del Propietario

OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Prepare the fuel tank for removal according to the appropriate vehicle service manual instructions and procedure. Drain the fuel
tank into a grounded storage container.
2. Pump the jack up so the fuel tank saddle adapter is close but not touching the vehicle's fuel tank. Attach the alligator clamp at the
end of one ground wire to the transmission jack. Attach the alligator clamp at the end of the other ground wire to the lift that is
supporting the vehicle. IMPORTANT: PROPER GROUNDING IS ACCOMPLISHED WITH THE ALLIGATOR CLAMPS AFFIXED TO
NON-PAINTED OR NON-COATED PARTS. THE LIFT SUPPORTING THE VEHICLE MUST ALSO BE GROUNDED TO THE EARTH.
3. Adjust the saddle adapter's arm assemblies, height adjustment tubes and support pad assemblies to fit the fuel tank
configuration, and then center and balance the tank on the saddle adapter.
4. Raise the jack so the saddle adapter makes contact with the fuel tank, and make final adjustments. Make sure the locking knobs
are tight and detent pins are inserted completely through their corresponding tubes.
5. Secure the fuel tank to the saddle adapter by wrapping the two tie-down straps completely around the tank and saddle. Insert the
tie-down straps through their buckles and pull them tight.
6. Make sure the tank is free to be lowered all the way down and there are not obstructions. The jack must be lowered all the way
before the tank can be transported.

PREVENTATIVE MAINTENANCE

This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to
potential personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the saddle adapter in a well protected area where it will not be exposed to inclement weather, corrosive vapors,
abrasive dust, or any other harmful elements. The adapter must be cleaned of water, snow, sand, grit, oil, grease or other foreign
matter before using.
2. Every saddle adapter owner is responsible for keeping the adapter labels clean and readable. Use a mild soap solution to wash
external surfaces of the adapter.
3. Do not attempt to make any repairs unless you are a qualified repair person that is familiar with this equipment. Do not use the
saddle adapter if it is damaged, cracked, broken or missing parts. Take it out of service until replaced or properly repaired by an
authorized service center.
WARRANTY HANDLING PROCEDURES AND GUIDELINES FOR HD AND xD LIFTING EQUIPMENT
K-Tool International warrants that all jacks and service-related equipment will be free from defects in material and workmanship for a
period of 2 years following the original date of purchase. This warranty is extended to the original retail purchaser only. If any jack or
service-related item proves to be defective during this period, it will be replaced or repaired, at K-Tool International's option, without
charge. This warranty does not apply to damage from accident, overload, misuse or abuse, nor does it apply to any equipment which
has been altered or used with special attachments other than those recommended. This warranty does not cover repairs made by
anyone who is not a K-Tool International Professional Lifting Equipment Authorized Repair Center.
All HD and XD jacks or service-related equipment will be replaced or repaired at K-Tool International's option during the 2 year warranty
period.
During the 2 year warranty period, all alleged defective products must be shipped, freight prepaid, along with proof of date-of-purchase,
to your nearest K-Tool International Professional Lifting Equipment Authorized Warranty Center. Be certain to include your name,
address and phone number along with proof-of-purchase information, and a brief description of the alleged defect. The product will be
returned to the customer, freight prepaid.
Many alleged defectives may simply be handled by calling your nearest Service Center for parts. See pages 16 - 18 for a listing of
authorized warranty service centers.
In no event shall K-Tool International be liable for incidental or consequential damages. The liability on any claim for loss or damage
arising out of the sale, resale or use of a jack or related service equipment, shall in no event exceed the purchase price. SOME STATES
DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION
MAY NOT APPLY TO YOU.
THIS WARRANTY IS THE SOLE AND EXCLUSIVE WARRANTY PROVIDED IN CONNECTION WITH THE SALE OF K-TOOL
INTERNATIONAL PROFESSIONAL LIFTING EQUIPMENT. ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE
TO STATE.
KTI63136 4 7/14/14