Glacier bay VDR3322A1 Guía De Uso Y Cuidado página 6

Topmount Installation (continued)
4
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply.
Insert the faucet body (L) through the hole in the
sink.
6
Attaching the quick connector
to the receiving block
Push the quick connector (N) firmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
1
L
5
Securing the faucet assembly
From underneath the sink, secure the faucet
assembly to the sink with the FastMount™
system (M). Push the FastMount™ system (M)
up over the threads until it stops against the
bottom of the sink, then hand turn (clockwise)
to tighten (Fig 1).
7
Installing the weight
Install the weight clip (P) at the point of the
hose marking "weight here".
Insert the weight (O) onto the clip (P) by sliding
it down onto the clip (P).
Screw
Sink
Sink
Push
up
Fig 1