Uline H-6375 Manual Del Usuario página 2

3. Attach casters to axles. Put caster through the opening
in the axle and tighten with caster washer and large
nut. (See Figure 3) Repeat for remaining three casters.
Figure 3
Axle
4. Insert each gate end onto axle support. Insert round
head bolt and tighten with screwdriver. (See Figure 4)
5. Have a helper extend the gate and stand it upright
where it will be mounted. Drill a 3/4" diameter x 3"
deep hole, 1⁄" from wall into the floor for gate pin to
set into. Place a bearing washer over floor hole and set
bottom gate pin into floor mount hole. (See Figure 5)
Repeat on other side.
Gate Pin
Bearing Washer
CAUTION! Check to confirm gate will swing
away from opening when not in use. This will
provide a clear opening for normal traffic.
6. Extend gate and hang "L" bracket on top of gate to
verify where it will be mounted. To release tension, lift
the wheel 1/2 - 3/4" off the floor. Mark and drill pilot
holes into door frame or wall. It may be easier to drill
pilot holes if you remove the gate from its floor mount.
Place bearing washer and bottom gate pin back
into floor mount. Slip "L" bracket over top of gate and
5/16 x 2" lag bolt (not included.) (See Figure 6)
PAGE 2 OF 6
INSTALLATION CONTINUED
Figure 4
Figure 5
1-800-295-5510
uline.com
• Wood door frames or walls: 5/16 x 2" lag bolts.
• Steel door frames or walls: drill and tap for
5/16 x 2" lag bolts.
• Brick or concrete frames or walls: 5/16 x 2"
lag bolts set into 3/8" holes with lead anchors.
"L" Bracket
7. Raise center and side pins and use attached notch
to keep in place; this prevents damage to floor
surface. (See Figure 7) Extend and retract gate to its
stops to work out stiffness.
Center Pin
CAUTION! Notice that pins at this stage hit
the other half of gate or rest on floor. Do not
cut off pins.
8. With pins raised, extend both halves of gates
together to center of opening, mark floor for center
pin and drill 3/4" diameter x 3" deep hole. Lower pin.
Repeat for side pins. Open gates slowly at first to
avoid warping. (See Figure 8)
Figure 6
Side Pin Figure 7
Figure 8
0621 IH-6375