Surface Burners - Cetron JLEC201TBBE Manual De Usuario

12
Hose connector is included in the accessories bag. This illustration shows the
way it must be installed.
warning: use only a hose designed to carry gas

surface burners

warning: My cooktop is sealed and cannot be re-
moved to clean the interior since it is unnecessary.
my operation
a) electronic ignition using a button
1. Make sure I'm plugged into a live outlet.
2. Push in the knob and turn it to the desired set-
ting, in some models to the thunderbolt position.
3. Push in the electronic ignition button.
Once lit, release the button so the ignitor stops
sparking. To adjust the flame's size, turn knob to the
desired setting.
important!:
In the event of a power failure, you can light my surface burners using a
match.
b) match ignition.
1. Control knobs must be in the OFF position.
2. Bring a match near the burner, push in and turn the selected burner con-
trol knob, regulate flame to the desired size.
Hose
connector
Range
inlet pipe
Hose
clamp
Gas
hose
standard burners
They come in two sizes 3" and 4" diameter.
important! Before lighting my surface burners, make
sure caps are PROPERLY seated in their place (except
porcelain enamel burners). Pins must fit into the
burner's slot in order to assure its place.