Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDSQ4B/LDSQ6B Series Recessed LED Trim
INSTALLATION
1.
Place end of flexible conduit through frame opening
in ceiling exposing upper portion of quick disconnect
(Figure 2.).
2.
Remove LED engine from protective packaging.
3.
Remove trim assembly from protective packaging and
rotate side clips (3) outwards. (Figure 4.).
4.
Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 5.)
5.
Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 6.).
6.
Trim ring (optional) should be placed between the
ceiling and lower trim.
7 .
Properly align the connector as shown in (Figure 7 .).
Plug in the luminaire quick disconnect on the module.
8.
Ensure the connector is properly engaged. (Figure 8.).
9.
Install the LED engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 9.).
Height Adjustment
Thumb Screw
Rotational
Adjustment Thumb
Screws
Figure 1
Square Neck
Figure 2
2
Luminaire
Quick
Disconnect
Junction Box
Installation Instructions – LDSQ4B/LDSQ6B Series Recessed LED Trim www.eaton.com
LED
Engine
Trim Assembly
Figure 3
Figure 4
Figure 5
Figure 6
Torsion
Springs
Side Clips
Publicidad
