Cooking
3
Cooking
3.1 Filling
.
WARNING:
Danger of injury!
Check the appliance before each use. A
damaged appliance must never be used.
1. Take the appliance off of its base.
WARNING:
Danger of electric shock!
During filling, the underside of the appliance
and the base must by no means get wet –
this could cause a short-circuit of the con-
tacts in the base. Therefore, the outside of
the appliance must also be dry before set-
ting it onto the base.
2. Only put so much water or food into the
appliance that the content level is between
the "MIN" and "MAX" markings.
NOTE:
Take into account that the content level will
rise when other substances besides water
are put into the Hotpot°.
NOTE:
To save electricity, only heat the amount of
water you actually need at the moment.
18
NOTE:
You may fill the Aquagrad° either through
the filler and spout with the lid closed or with
the lid open. You can open the lid by push-
ing the release catch in the handle "
(Fig. 3).
3
3. Close the lid.
4. Put the appliance back onto its base.
3.2 First use
1. Fill the appliance with water up to the
"MAX" marking ( Chapter 3.1, "Filling").
2. Bring the water to a boil ( Chapter 3.3,
"Daily use") and pour it away completely;
repeat this once or twice.
"
<